Compressed air is one of the most expensive forms of energy in a factory. The right compressor, drying, pipe design and leak management make a direct difference to the energy bill.
Compressed air is widely used in pneumatic machinery, packaging lines, painting and cleaning. Although it seems an easy and safe energy source, most of the electricity a compressor uses turns into heat. Designing the compressed air system efficiently therefore has a major effect on a factory’s operating costs.
System components
- Compressors: Screw compressors are the most common type in industry. With variable demand, a variable-speed compressor saves energy compared with fixed-speed units.
- Air receiver: Smooths demand fluctuations and prevents frequent compressor cycling.
- Dryers and filters: Reduce moisture, oil and particles to the required quality.
- Distribution network: Carries air to the points of use without loss and at sufficient pressure.
- Control system: Sequences and monitors several compressors according to demand.
Air quality
Not every use needs the same air quality. Food, pharmaceutical and packaging plants need oil-free, very dry air, while general pneumatic use may accept lower quality. Air quality is defined in ISO 8573-1 by particle, moisture and oil classes. Choosing higher quality than needed means unnecessary energy and maintenance costs; choosing lower quality means product and machine problems.
Pipe design
Pressure loss in the network forces the compressor to run at higher pressure and use more energy. A ring main lets air reach points of use from two directions and reduces pressure loss. Taking branches from the top of the main, laying the main with a fall and fitting condensate drains at low points keep water out of the pipes. Aluminium compressed air piping systems offer fast installation and low friction loss.
Leaks and heat recovery
Leaks often waste a significant share of the air produced without anyone noticing. Regular leak surveys at joints, hoses and idle machines are the improvement with the fastest payback. The heat produced by compressors can also be recovered for process water or space heating.
The compressor room
Good ventilation of the compressor room, so that compressors draw in cool air and hot air is exhausted outside, improves efficiency. Maintenance clearances, acoustic insulation and discharging condensate through an oil separator should also be planned in the design.
Conclusion
A well-designed compressed air system meets the factory’s needs with the least energy. At Ekura, we install compressed air systems in factories from the compressor room to the points of use; Korozo Packaging Kıraç Factory is one of these projects. Learn more about our gas and process piping solutions.
Let's talk about your project.
A site survey, a quote or a technical question — our team will listen to your project and work with you to define the right solution.
