The hidden systemsof an aircraft hangar.
From flame detection to foam suppression, from radiant heating to pre-conditioned air for the aircraft: the mechanical systems of a maintenance hangar. At the end we will follow a hangar fire from start to finish.
A fire is seenwithin seconds.
UV/IR flame detectors on the hangar walls watch the entire floor. To prevent false alarms, suppression starts when two detectors confirm the same fire; the fire panel raises the alarm and starts the pumps and valves.
Foam-waterfrom the roof.
An open-head deluge system covers the hangar ceiling. When the deluge valve opens, all heads in the zone discharge foam-water at once; the fuselage and the fuel on the floor are covered.
The hangar flooris covered with foam.
Generators on the walls turn a small amount of foam solution into a very large volume of foam. The foam quickly fills the hangar floor up to wing level and extinguishes the fuel fire by cutting off its air.
Smoke and heatleave at the top.
When the fire is confirmed, the vents on the roof open; hot smoke and heat are released, protecting the roof structure and the aircraft. The vents also help release the air displaced by high-expansion foam.
Targeted foamunder the wing.
Water from the ceiling cannot reach under the wings and engines well enough. Oscillating foam monitors on the floor target these areas and knock down the fuel fire at its source.
A fire,from start to finish.
Fuel leaking under the wing ignites. Follow the steps below; the scene changes at every step and the simulation restarts about every 30 seconds.
Foam inthe right ratio.
Concentrate from the foam concentrate tank is mixed into the fire water at the right ratio in the proportioner. The resulting foam solution goes to the deluge, monitor and generator lines.
Water arriveseven in a power cut.
The electric main pump, the diesel pump that starts in a power cut and the jockey pump that keeps the line under pressure are fed from the fire water tank. The pumps are kept ready with weekly tests.
Fuel and foam go to the separator,not the sewer.
Floor drainage channels collect leaking fuel and firefighting water; the fuel/oil separator separates them and releases clean water to the sewer. Fuel does not spread along the channel and the fire does not grow.
Efficient heatingunder a high roof.
Radiant tube heaters warm the aircraft, the floor and the staff rather than the air. Destratification fans bring warm air collected under the roof back down, so no energy is wasted in the large volume.
Door open,heat stays in.
When the giant hangar door opens, the air curtain above it forms a wall of air and reduces cold air flowing in; heaters and fans step up gradually.
Cabin comfortwithout running the engines.
The PCA unit supplies conditioned air to the cabin without running the aircraft's auxiliary power unit; fuel use and noise are reduced. Hose reels on the hangar wall supply compressed air to maintenance equipment.
The right environmentfor the maintenance team.
The workshop and offices are air-conditioned with a VRF system. The composite and paint booth exhaust carries vapours and particles away from the work area.
Sanding dustnever reaches the lungs.
Downdraft sanding tables and central vacuum outlets in the hangar capture dust at the source. Dust is pre-separated in a cyclone and held in a cartridge filter; because composite dust is combustible, the filter unit has an explosion vent.
The whole hangaron one screen.
Flame detectors, deluge valves, monitors, pumps, foam level and building systems are monitored from a single screen. Choose a scenario and see how the screen and the hangar change.
Let's plan your hangar projecttogether.
Let's review your project together before installation; we install the fire suppression and mechanical systems, carry out foam tests and commissioning, and hand them over.
